| Product Identification | Back to Contents | 【Product Name】
Chloromethyltriethoxysilane | 【Synonyms】
(Chloromethyl)triethoxysilane
Silane, triethoxy(chloromethyl)- | 【CAS】
15267-95-5 | 【Formula】
C7H17ClO3Si | 【Molecular Weight】
212.78 | 【EINECS】
239-311-3 | 【RTECS】
VV2275000 | 【RTECS Class】
Primary Irritant | 【Beilstein/Gmelin】
1811785 | 【Beilstein Reference】
4-01-00-03074 |
| First Aid Measures | Back to Contents | 【Ingestion】
Seek medical assistance. | 【Inhalation】
Move victim to fresh air. Apply artificial respiration if victim is not breathing. Do not use mouth-to-mouth method if victim ingested or inhaled the substance; induce artificial respiration with the aid of a pocket mask equipped with a one-way valve or other proper respiratory medical device. Administer oxygen if breathing is difficult. | 【Skin】
Remove and isolate contaminated clothing and shoes. Immediately flush with running water for at least 20 minutes. For minor skin contact, avoid spreading material on unaffected skin. | 【Eyes】
Immediately flush with running water for at least 20 minutes. |
| Handling and Storage | Back to Contents | 【Storage】
Keep in a cool, dry, dark location in a tightly sealed container or cylinder. Keep away from incompatible materials, ignition sources and untrained individuals. Secure and label area. Protect containers/cylinders from physical damage. | 【Handling】
All chemicals should be considered hazardous. Avoid direct physical contact. Use appropriate, approved safety equipment. Untrained individuals should not handle this chemical or its container. Handling should occur in a chemical fume hood. |
| Hazards Identification | Back to Contents | 【Ingestion】
See Inhalation. | 【Inhalation】
TOXIC; inhalation, ingestion or contact (skin, eyes) with vapors, dusts or substance may cause severe injury, burns, or death. Effects may be delayed. | 【Skin】
See Inhalation. | 【Eyes】
See Inhalation. | 【Hazards】
Vapors form explosive mixtures with air: indoors, outdoors, and sewers explosion hazards. Most vapors are heavier than air. They will spread along ground and collect in low or confined areas (sewers, basements, tanks). Vapors may travel to source of ignition and flash back. Substance will react with water (some violently) releasing flammable, toxic or corrosive gases and runoff. | 【UN (DOT)】
2985 |
| Fire Fighting Measures | Back to Contents | 【Fire Fighting】
Note: Most foams will react with the material and release corrosive/toxic gases. Small Fires: carbon dioxide, dry chemical, dry sand, alcohol-resistant foam. Large Fires: Water spray, fog or alcohol-resistant foam. | 【Fire Potential】
HIGHLY FLAMMABLE: Will be easily ignited by heat, sparks or flames. |
| Accidental Release Measures | Back to Contents | 【Small spills/leaks】
ELIMINATE all ignition sources and groumd all equipment used when handling the product. Do not touch spilled material unless wearing appropriate protective clothing. Stop leak if you can do it without risk. A vapor suppressing foam may be used to reduce vapors. FOR CHLOROSILANES, use AFFF alcohol-resistant medium expansion foam to reduce vapors. DO NOT GET WATER on spilled substance or inside containers. Cover with DRY earth, DRY sand, or other non-combustible material followed with plastic sheet to minimize spreading or contact with rain. Use clean non-sparking tools to collect material and place it into loosley covered plastic containers for later disposal. |
|
| Company Name: |
J & K SCIENTIFIC LTD. |
| Tel: |
010-82848833 400-666-7788 |
| Fax: |
86-10-82849933 |
| WebSite: |
http://www.jkchemical.com |
|