PEEK manufacturers and suppliers in india

PEEK

Properties

Melting point:: 322°C

Density: 1.3 g/mL at 25 °C(lit.)

solubility: all common solvents: insoluble

Safety Information

WGK Germany: 3

Use

PEEK can be injection-molded, compression- molded, or extruded into stock shapes, which are typically machined to final-part dimensions. Most pump components can be injection-molded as long as they do not require tight tolerances. The strict tolerances required for bushings and wear rings require parts to be machined from molded tube stock.Replacing bronze and steel wear rings with carbon-filled or carbon-reinforced PEEK components, allows manufacturers to increase pump efficiency by achieving tighter clearances. PEEK resins also reduce vibrations caused by fluid flow across wear rings and excess rotor runout. The ductility of plastic pump components helps them outperform metal versions when it comes to reducing vibration, as well as resisting impact.